Quick start

Follow these steps to set up and use I2C Protocol Exerciser:

Setup steps

1. Select bus - Choose which bus to use for your I2C communication
2. Configure PX pair parameters - Set controller/target mode, voltage, and pull-up resistors
3. (Optional) Add internal nodes - Create virtual I2C devices in your topology
4. (Optional) Configure DC output - Power your device under test
5. Configure decode settings - Set Logic Analyzer parameters for I2C signal analysis
6. Assign topology - Upload configuration to the exerciser device

Controller mode operations

In Controller mode, you can perform additional operations:

1. (Optional) Scan for devices - Scan all available addresses (0x08 ~ 0x77) to detect connected devices
2. Send commands - Use the I2C wizard to send READ/WRITE transactions